1999 Ford Taurus Camshaft Position (CMP) Sensor SHO Removal Installation
download Camshaft Position (CMP) Sensor SHO Removal 1. Disconnect battery ground cable (14301) . Refer to Section 14-01. 2. Remove the engine appearance cover. For additional information, refer to...
View Article2007-2008 Ford Explorer Sport Trac SPARK PLUG REMOVAL INSTRUCTIONS
download FORD: 2005-2008 Mustang 2004-2008 F-150 2005 Excursion 2005-2008 Expedition, F-Super Duty 2006-2008 Explorer, F-53 Motorhome Chassis 2007-2008 Explorer Sport Trac This article supersedes TSB...
View Article2002 Jeep Wrangler CMP and CKP Removal and Installation
download The Camshaft Position Sensor (CMP) on the 4.0L 6cylinder engine is bolted to the top of the oil pump drive shaft assembly. The sensor and drive shaft assembly is located on the right side of...
View Article2007-2008 Pontiac Torrent GM Accessories Headrest DVD System Display Monitor...
download GM Accessories Headrest DVD System Display Monitor Inoperative (Install Cable Connector Clamps) 2004-2007 Buick Rainier 2008 Buick Enclave 2003-2008 Cadillac Escalade Models 2005-2008 Cadillac...
View Article2008-2009 Pontiac G6 GXP 2008-2009 Pontiac G8 2008-2009 Pontiac Torrent GXP...
download Installation Instructions Part Number 200-630 2008-09 Buick Enclave 2008-09 Chevrolet Equinox Sp. 2008-09 Chevrolet Malibu 2008-09 Chevrolet Traverse 2008-09 GMC Acadia 2008-09 Pontiac G6 GXP...
View Article2003-2006 Chevrolet Express Antilock Brake (ABS) Activation At Low Speeds...
download Condition Some customers may comment on ABS activation at low speeds, usually below 8 km/h (5 mph). Upon investigation, the technician will find no DTCs set. Cause The cause of this condition...
View Article2002 Kia Spectra SENDING UNITS & SENSORS LOCATION
download Air Quality Sensor At center front of engine compartment. Camshaft Position Sensor On rear of cylinder head. See Fig. 1 . Chassis Acceleration Sensor At right rear side of engine compartment....
View Article1999 Jeep Cherokee Limited DTC P0117: ECT SENSOR VOLTAGE TOO LOW
download 1. Turn ignition on, with engine off. Using scan tool, read ECT sensor voltage. If voltage is less than .5 volt, go to next step. If voltage is .5 volt or more, go to step 6). 2. Turn ignition...
View Article1998 Ford Windstar Camshaft Position (CMP) Sensor REMOVAL AND INSTALLATION
download CAUTION: Prior to removal of the camshaft position sensor (CMP sensor) (12126) , set cylinder No.1 to zero degrees top dead center (TDC) of compression stroke. Then note the position of the...
View Article1995 Ford Mustang Camshaft Position (CMP) Sensor Removal Installation
download 1. Disconnect battery ground cable (14301) . 2. Disconnect fuel charging wiring (9D930) from distributor stator (12A112) (camshaft position sensor). 3. Remove stator camshaft position sensor...
View Article
